Commercial scraping door mat. Solid rubber.

430 Comfort Scrape can be used for multiple applications. Such as out door entrance ways, kitchen areas, behind bars, dish stations, or even in an industrial setting that is in need of an anti-slip mat. It is made of closed cell Nitrile Rubber cushion that is high density and has an added anti-slip top surface - 15% of the material is recycled content. Comfort Scrape is designed in a low/high alternating herringbone pattern. It is 3/8" thick and should clear most door swings. Material will not absorb odors, is UV stable, and is resistant to grease, oil, and most chemicals. It is not only static dissipative but is also weld safe for industrial settings. All material is coated with a life time anti-microbial to prevent degradation and again to prevent odors. Material can also be autoclave sterilized. Each mat comes with a beveled edge on all four sides for a safer floor transition for foot traffic and carts as well. Mat is certified slip resistant and has been tested for a number of different situations, for the positive results continue reading below. Light in weight and flexible for cleaning, storage, or moving. Comfort Flow Grit is available in four standard ship the fastest sizes sure to meet your matting needs.

Ideal for outdoor use as a scrapper mat, as well as any area where water is a tripping hazard. Aside from its durability and long lasting material - Maintenance is a breeze, a few suggestions on cleaning are below.

Sweep off as needed – Can be washed with a garden hose. Hang to dry before putting back into use. For a deeper clean use a non-bleach natural PH detergent rinsing thoroughly before placing back into use. Can also be washed in a commercial dishwasher.

430 Comfort Scrape Matting has been independently tested in the following conditions yielding positive results:

• Passes Flammability Standard DOC-FF-1-70
• Static Dissipative: Surface to Ground 50%, Relative Humidity 3.7 x 10^8 OHMS / Surface to Ground 12%, Relative Humidity 4.5 x 10^8 OHMS / Surface to Surface 50% Relative Humidity 9.1 x 10^8 OHMS / Surface to Surface 12% Relative Humidity 9.5 x 10^8 OHMS.
• AATCC Method: 134-1991 Electrostatic Propensity of Carpets - Maximum Voltage Negative 0.3KV.
• Static Coefficient of Friction (ASTM C1028-96): Dry .70 / Wet .69